Step by step easy CPE assembling
Photo

Step 1

Open the CPE enclosure package and verify its content:
• 1 enclosure cover with 15dBi 2,4GHz pre-assembled antenna
• 1 enclosure plate
• 1 RJ45 pre-assembled data cable
• 1 MMCX-SMA male 90° coaxial pigtail
• 4 short screws
• 16 long screws
• 1 mast mounting kit

Photo

Step 2

The kit is supplied with the 15dBi 2,4GHz panel antenna assembly already attached to the enclosure cover.
Connect the SMA male 90° end of the pigtail to the female connector on the antenna assembly.
Attach the Routerboard (not supplied with the kit) to the spacers on the antenna base plate using the 4 short screws.

Photo

Step 3

Connect the MMCX end of the pigtail to the connector on the board.

Photo

Step 4

Mount the socket end of the pre-assembled RJ45 cable into the hole of the enclosure back plate. Make sure that the plastic nut is well tightened.

Photo

Step 5

Insert the RJ45 connector into the ethernet port of the Routerboard.

Photo

Step 6

Close the CPE by attaching the enclosure back plate to the cover with the 16 long screws.

Photo

Step 7

Well done !!!
Now you can start to use your MikroTik powered 2,4GHz 15dBi CPE

Photo

Step 8

Install the assembled CPE using the supplied hardware.

First step
1
Second step
2
Third step
3
Fourth step
4
Fifth step
5
Sixth step
6
Seventh step
7
Eighth step
8